MUZZA RIG: STEP 1

These are the components that you need to tie Tom Dove's muzza rig.

MUZZA RIG: STEP 2

Pull off 16 inches of N-Trap Soft and strip back seven inches of coating.

MUZZA RIG: STEP 3

Now tie an overhand loop in the end of the unstripped section.

MUZZA RIG: STEP 4

Carefully drill 1cm into the centre of an 18mm bait.

MUZZA RIG: STEP 5

This is how the bait should look when drilled out.

MUZZA RIG: STEP 6

Insert a cork stick and trim off the stick as indicated.

MUZZA RIG: STEP 7

You should be left with a small amount sticking out.

MUZZA RIG: STEP 8

Now pierce the bait with a fine gated needle.

MUZZA RIG: STEP 9

Thread the bait onto the hair and secured it with a hair stop.

MUZZA RIG: STEP 10

Slide a Kurv Shank onto the link and position it like this.

MUZZA RIG: STEP 11

Make two turns up the shank, knotless knot fashion.

MUZZA RIG: STEP 12

Pull the hair away from the shank and continue to make turns up the shank.

MUZZA RIG: STEP 13

Make nine turns up the shank, above the hair.

MUZZA RIG: STEP 14

That's the finished hooking arrangement.

MUZZA RIG: STEP 15

Tie the link to a Ring Swivel, using a grinner knot.

MUZZA RIG: STEP 16

That's the finished rig, give it a try over scattered boilies.