IQ D-Rig (Print)

STEP 1

Here's the selection of kit that you need to tie the IQ-D-rig.

STEP 2

Start by taking a 14-inch length of IQ fluorocarbon.

STEP 3

Hold the hook between your fingers and pinch a large loop of IQ against the shank, like this.

STEP 4

Take the upper part of the loop and wrap it once around the shank, up towards the bend.

STEP 5

Now wrap around the hook again, but back down towards the eye this time, crossing over the first wrap.

STEP 6

Continue wrapping down the shank.

STEP 7

Pull both ends tight to tighten the barrel of the knot.

STEP 8

Snip off the tag that projects down towards the eye. The rig should now look like this.

STEP 9

Slide a Micro Rig Swivel down the IQ.

STEP 10

Now tie a six turn knotless knot with the long tag, securing the hook like you would normally.

STEP 11

Slide a small Sinker down onto the hook link, positioning it two inches above the hook.

STEP 12

Now set the rig at around nine inches and tie a Link Loop to the other end, using a half-blood knot.

STEP 13

Now mould a small amount of putty around the Sinker.

STEP 14

Pull a wafter hook bait onto a doubled piece of bait floss and tie the tags around a boilie stop to secure the bait.

STEP 15

Trim the tags and blob with a lighter.

STEP 16

The rig is now ready to use!